It is a complex process to configure a RM4200D, and there are numerous ways to get it done. Often, there is not set order of the individual steps. Despite this, the following list offers a suggestion for how to configure a “brand new” RM4200D. The list is neither complete nor is it very detailed, but it offers a rough overview of the configuration process:
Set the general options for the RM4200D Device. (see Device Properties )
Select the desired slot cards for the DSP frame and assign the labels for audio and control signals. (see DSP Frame I/O — Configuring the DSP Frame)
Place the desired modules in the mounting frame and assign functions to the keys of the Console. (see Console – Configuring the Console )
Configure the Audio System with monitors, internal buses, Fader Channels and so on. (see Configuring the Audio System )
Configure the Logic System to include key functions, GPIOs etc. (see Configuring the Logic System )
Connect the audio signals and logic functions to Output Functions. (see Output Functions)
Route the audio signals on the TDM bus to the outputs of the RM4200D. (see Output Routing )