- spare part for specific MX fader modules with “red” connector on PCB
- adapts “red” connecot to “white” connector on new P&G faders
FADER-CON-RD
red connector fader adapter
Preferred productIn stock
Properties
| Remarks: | Note: Order this adapter if there is no "white" connector for fader available on printed circuit board (PCB) of fader module.
Adapter works for both "red" 4-pin or "red" 6-pin connector on the PCB. In case of a "red" 4-pin connector, 2 pins of the 6-pole ribbon cable connector are not connected to the PCB, only one position is mechanically possible. Use also for conversion of Alps Fader modules 52-4250A, 52-4240A, 52-4260A, 52-4231A, 52-4241A, 52-4261A to Penny & Giles. Note that all faders connected to the same controller must use the same fader type, note correct controller dip-switch settings when using Penny & Giles instead of Alps motor faders. |
