In this tab, you can define Input Pools and name them. Input Pools are used to alternatively use different sources on faders. To switch between the available signals, the functions Input Select or ACCESS Input Select are available.

You define the assignment of the sources to the individual Input Pools under Audio System/Fader Channels. (see also Fader Channels – Configuring Signal Sources for Faders)

A pool named Pool 1 is pre-defined in the dialog. You can create further pools using the button Add or delete them with the button Remove. A maximum of 15 different pools can be defined.

To change the name of a pool, select it in the list and then change its name in the field Label. The name can have a maximum length of up to 7 characters; it is displayed in the display of the Control Modules RM420-010/011/012/013, if Input Select or ACCESS Input Select was activated in a Fader Module.

	Note
	To be as flexible as possible for fader assignment during operation of the RM4200D, you should configure only one Input Pool.