To assign a fader channel to a program bus, just press the key Program 1 or Program 2 on top of the fader channel. If the fader channel was already routed to the program bus, it will be switched off, if not, it will be switched on. In any case, the LED below the keys will be lit, if the fader channel is currently assigned to a program bus.

If you are using the RM2200D software and a fader channel is selected, the Full Screen Display will reflect your changes in the section Busses. You can also use the software to change the settings from the PC.

	Note
	Please note that you can use the RM2200D software to change the way the two Program keys behave. You can lock any of them independently when the fader is open. You can also set them to toggle each other for Off-Air operation. In this case, switching one program bus on switches the other one off and vice versa. (see also Mod. Options - Configuring Module Options)