This part of the RM4200D manual explains the use of the configuration software Toolbox4. This program is used for the configuration of all system functions and for adjusting these functions to their specific use. Additionally, the software can be used for special maintenance and service functions of already configured systems (the so called “Maintenance Functions”).

The Toolbox4 software is used by DHD, its partners and specifically trained service personnel.

	Note
	The Toolbox4 software is designed exclusively for the configuration and maintenance of RM4200D systems by authorized personnel. It is not required for the daily use of the system and is not to be used by end users. Access to the program should therefore be regulated via access control mechanisms in operating systems and networks.

The software was developed for use on Windows XP. The use with other Windows operating systems has not been tested and can lead to restrictions (e.g. in graphic display).

	Warning
	The firmware of the RM4200D and the functions of the Toolbox4 software are closely related to each other. Please make sure that only matching versions of firmware and Toolbox 4 software are used together. (Find more information on that topic later in chapter 1.)

This book was last changed on March, 27th 2006.